Dive Rite O2ptima Owner's Manual download pdf (Page 48)

Dive Rite

Ch. 6 Pg. 6

D I V A

The DIVA ships from the factory as an assembled unit. The DIVA

needs to be mounted to the DSV. The O2ptima DSV has TWO

locations for the diver. The diva can be positioned so that it can be

viewed by either the diver’s right or left eye. To install line up the

screw hole on the DIVA mount and use the thumb screw supplied

with the DSV to secure.

A hood is shipped with the O2ptima to improve the visibility in bright conditions. The hood is a

cap that fits over the LED end of the DIVA. It has an opening on one side only which should face

the diver. This hood shields the DIVA from ambient light allowing the diver to see the LED even

in very bright conditions. The hood is only recommended for use in bright conditions because it

also prevents the diver’s buddy from seeing the LED in the DIVA. The visual indicator in the

DIVA under low light conditions is easily visible to all the diver’s around and may alert a buddy

to a trouble even before the diver realizes there may be a problem.

Once the DIVA is mounted and the hoses are all connected, the diva cable should be wrapped

around the breathing hose and routed up to the DIVA connector on the head. The O2ptima must

NEVER be used with the DIVA connector on the head exposed! The cable must be fully

plugged into the socket and securely tightened (do not use any tools) in order for a water tight

connection. Alternate between tightening the locking ring and trying to seat the plug further into

the socket. Continue until no further tightening is possible. The connector on the head and the

cable end should be periodically cleaned with a suitable contact cleaner.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 57 58

No comments

Dive Rite O2ptima Owner's Manual Page 48