Dive Rite NiTek He Owner's Manual download pdf (Page 22)

NiTek

/NiTek

Owner’s Manual Page 22

➤ NiTek

s will emit a three-beep audible signal as soon water immerses all of its

exposed electrical contacts. For approximately the next three seconds, its display

will continue to show all the information it did while in Surface Mode, plus the

current FO

setting. The screen will then change to the regular Dive Mode display,

described in Figure 8.

➤ NiTek

s will emit the same three-beep audible signal as NiTek

s do. Then, for

approximately the next ﬁ ve seconds, its screen will show what it did while in

Surface Mode, plus scroll though mix 1, 2 and 3, displaying the current FO

setting for each. It will then enter Dive Mode, just as the NiTek

does.

Prior to descending, always hold your NiTek just below the

surface and check one ﬁ nal time to ensure the FO

and Gas

Mixture settings are correct.

➤ If, just prior to descending, you discover that one or more FO

settings are

incorrect (or in default), simply lift the computer out of the water and make the

necessary changes.

➤ If you are using a NiTek

, and see that it is set to the wrong starting gas

mixture, you needn’t remove the computer from the water. Simply follow the same

procedure you would follow to change gas mixtures during a dive. We will cover

this shortly.

Figure 8: Dive Mode (No Decompression).

What you will see: When you ﬁ rst enter Dive Mode,the NiTek will display a variety

of data, including:

1. Current Depth—The depth at which the NiTek is at right now.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 45 46

No comments

Dive Rite NiTek He Owner's Manual Page 22